AX3516 VETO PROPAC USA ''TECH-MC'' tool bag 

The Tech Pac MC is a compact tool backpack tool bag designed for Techs that need to hands-free carry a minimum amount of tools and test meters for service calls and minor installs.  This is perfect for mobile tool storage.

PRODUCT SPECIFICATIONS:

• Height: 173 (43cm)
• Width: 12 (30.5cm)
• Depth: 9 (23cm)
• Handle Height: 19" (48cm)
• Weight (empty): 8 lbs. (3.5kg)
• Max Payload: 35lbs (16kg)
• Internal Volume: 1100in3/18L

MAXIMISED TOOL STORAGE CAPACITY:

• Vertical Tool Pockets: 39 Interior and Exterior
• Neoprene Meter Pockets
• Interior Magnetic Screw Catcher
• 2 Storage Bays- 4 Storage Platforms
• Padded EVA Thermoformed Ergonomic Back Padding
• 8" Electrical Tape Strap
• Gray Pockets For Better Visibility
• Upper Pockets (Front Side) Designed For Extra Tool Capacity
• Waterproof & Abrasion Resistant Hard Bottom
• Waterproof 3mm Polypropylene Base
• Quick Release Metal Hasp Allows Easy Access To Rear Storage Bay & Positive Connection To Bag Body
• YKK Locking Zippers

RUGGED MATERIALS & CONSTRUCTION

• D-Rings: Powder Coated Steel

VETO PRO PAC - TOOL BAGS PRODUCT CARE & MAINTENANCE

Keep your zippers clean and properly lubricated

Over time, dirt and grime will clog your zipper coils, preventing them from staying closed. To prevent this from happening, clean and lubricate your zippers twice a year (more often if you work on a dusty construction site).

To clean the coils: Scrub them with soapy water, using a toothbrush. After scrubbing the coils, blow them with air to remove any other fine hairs that were not removed with the brush. To lubricate the coils: Apply a silicone spray, beeswax, or zipper lubricant.

Protect zippers from sharp objects and excessive heat

Any sharp object or heat source can permanently damage zippers. Once a zipper coil is cut or snapped, the zipper will not work and in most cases cannot be repaired.

Most of the cut zipper coils we see are the result of sharp tools being stored inside the bag with the sharp side facing up. Be sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.

Do not overstuff the bag.

Overloading your tool bag will most likely cause significant stress on the zippers, above and beyond what they were designed for and will eventually cause the zipper(s) to separate.

If you have to strain to close your zipper, your tool bag is probably too full... Remove something, rearrange, or proceed with caution, always keeping in mind that you risk violating the terms of your warranty.

Learn more about the AX3516 VETO PROPAC USA ''TECH-MC'' tool bag here