TP3B Tool Pouch VETO PROPAC USA 

The TP3B tool pouch is a “Next Generation” revised version of the TP3 with a Hard Bottom, extra tool pocket depth and riveted stainless steel tape measure clip. This tool pouch stands up and is bottom protected.  It’s the perfect tool storage to help carry and help organize your most needed tools for any job or service call. It also has a streamlined metal clip on the back.

PRODUCT SPECIFICATIONS:

• Height (H): 11" (28cm)
• Width (W): 6.5” (16.5cm)
• Depth (D): 5” (12.5cm)
• Weight (empty): 1.5lbs (.5kg)
• Max Payload: 10lbs (4.5kg)
• Internal Volume: 205in3 (3.5L)

MAXIMIZED TOOL STORAGE CAPACITY:

• Vertical Tool Pockets: 16 interior and exterior of various sizes
• Includes 2 Vertical Long Shank Side Tool Pockets
• Belt Slot
• Low Profile Metal Belt Clip
• Quick Clip Metal Tape Holder
• Meter Pocket
• Bit Extension Pockets

RUGGED MATERIALS & CONSTRUCTION

• Leather Trim Panels
• D-Rings: Powder Coated Steel
• 12000 Polyester Tool Pockets & Body Fabric

OTHER FEATURES:

• Detachable Rubber Handle
• D-Rings: 2 small
• 8" Electrical Tape Strap With Swivel Hooks
• Nylon Plastic Connection Clip
• Warranty: 5 Years (see Veto warranty terms and conditions)

VETO PRO PAC - TOOL BAGS PRODUCT CARE & MAINTENANCE

Keep your zippers clean and properly lubricated

Over time, dirt and grime will clog your zipper coils, preventing them from staying closed. To prevent this from happening, clean and lubricate your zippers twice a year (more often if you work on a dusty construction site).

To clean the coils: Scrub them with soapy water, using a toothbrush. After scrubbing the coils, blow them with air to remove any other fine hairs that were not removed with the brush. To lubricate the coils: Apply a silicone spray, beeswax, or zipper lubricant.

Protect zippers from sharp objects and excessive heat

Any sharp object or heat source can permanently damage zippers. Once a zipper coil is cut or snapped, the zipper will not work and in most cases cannot be repaired.

Most of the cut zipper coils we see are the result of sharp tools being stored inside the bag with the sharp side facing up. Be sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.

Do not overstuff the bag.

Overloading your tool bag will most likely cause significant stress on the zippers, above and beyond what they were designed for and will eventually cause the zipper(s) to separate.

If you have to strain to close your zipper, your tool bag is probably too full... Remove something, rearrange, or proceed with caution, always keeping in mind that you risk violating the terms of your warranty.

Learn more about the TP3B Tool Pouch VETO PROPAC USA here