VETO PROPAC USA MB Small Meter Tool Pouch AX3507

For the tradesman who really wants to look after his tools and equipment, know where they are when he is working, access them and make life on site easier, there is no better labour saving device than a Veto Pro Pac bag. 

The MB is a clip-on bag designed to hold a small selection of tools and meters. An HVAC/R essential to carry the more common of tools to diagnose and repair problems on service calls.

Incorporating 53 pockets (50 interior & 3 exterior) for hand tools, parts, meters, refridge & cordless tools, heavy duty fastenings and zips, waterproof Polypropylene base, double stitched, heavy duty plastic coil zips with oversize zip tabs, marine grade zinc studs, powder coated steel D- Ringsand industrial strength double nylon stitching.

Built to last, it is supplied with the ultimate vote of confidence - a 5 Year warranty.

VETO PRO PAC - TOOL BAGS PRODUCT CARE & MAINTENANCE

Keep your zippers clean and properly lubricated

Over time, dirt and grime will clog your zipper coils, preventing them from staying closed. To prevent this from happening, clean and lubricate your zippers twice a year (more often if you work on a dusty construction site).

To clean the coils: Scrub them with soapy water, using a toothbrush. After scrubbing the coils, blow them with air to remove any other fine hairs that were not removed with the brush. To lubricate the coils: Apply a silicone spray, beeswax, or zipper lubricant.

Protect zippers from sharp objects and excessive heat

Any sharp object or heat source can permanently damage zippers. Once a zipper coil is cut or snapped, the zipper will not work and in most cases cannot be repaired.

Most of the cut zipper coils we see are the result of sharp tools being stored inside the bag with the sharp side facing up. Be sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.

Do not overstuff the bag.

Overloading your tool bag will most likely cause significant stress on the zippers, above and beyond what they were designed for and will eventually cause the zipper(s) to separate.

If you have to strain to close your zipper, your tool bag is probably too full... Remove something, rearrange, or proceed with caution, always keeping in mind that you risk violating the terms of your warranty.