VACUUM GAUGE digital VG-60,SUPCO...

VACUUM GAUGE digital VG-60,SUPCO...

A durable self-contained battery powered vacuum gauge which displays the level of vacuum on a LED color coded read out. Allows for reading in ten segments from atmosphere to 50 Microns. The unique design of the VG60 allows for in-line connection through the system or directly at the vacuum pump. Built-in hanger and stand support for remote connections. Furnished with a vinyl protective case. Sensor Type: Thermistor. Connector Type: Standard 1/4" male flare fitting. Vacuum Range: 50 - 5000 Microns. Scale: Microns - 10 LED segments atmosphere to 50 Microns. Overpressure: 500 psi max (20 bar). Power Source: 9 V battery (not included). Measures 1-3/4" width 5-1/2" height 1-1/2" depth. Weight: 6.8 oz. 

Frequently Asked Questions:

• What is the maximum amount of turns to calibrate? 15 turns maximum. 
• What is the accuracy? Supco has no specified accuracy for the VG60. Although Supco does calibrate all VG60's to within 10 % of an NIST (National Institute Of Standards & Technology) certified VG60 @ 100 microns. 
• When the VG60 is turned on, it reads 5,000 microns and then drops down and to 50 microns and stays there?
• The Micron pressure readings have been calibrated at the factory. It is permanent and never needs resetting. However, due to seasonal temperature variations you may have to make a slight ambient adjustment. The gauge is perfectly calibrated when after you push the slide switch to ON , both the Atmosphere and Slide switch lamps are energized. Should the 5,000 micron lamp go on instead of the Atmosphere lamp, insert a small screw driver (included) into the opening at the side of the case, locate the screw and make the adjustment until only the Atmosphere and slide switch lamps go on. Do not overturn the screw, it may turn off the Atmosphere lamp. This information is available in the VG60 instructions under Calibrations.